25 Jan 2021
Replacing the mechanical seal on the STUART pump We offer all kinds of mechanical seals for Stuart Turner pumps, including Stuart Turner Monsoon M330N, M550N, Monsoon N 1.5 bar, N 2.0 bar, N 3.0 bar, U 1.5 bar, U 2.0 bar, U 3.0 bar, ST 55, ST 66, ST 15, ST 20 and many others. Stuart Turner Monsoon - high-performance brass... Read more →
12 Jan 2021
The DAB CP 50/2200 T circulation In-line pump for pumping liquids free of abrasive and chemical substances is equipped with: hydraulic housing with support for the engine made of gray cast iron, impeller made of technopolymer, feed rotor-stainless steel. For reliable operation of the pump, two types of seal are used: EPDM seal and mechanical... Read more →
12 Jan 2021
The mechanical seal in the pump Wilo IPN50/200-1,1/4-IE1 (120910792) was replaced with R-MG1S20 Wilo IPN-single-stage centrifugal pumps with sliding mechanical seal, used for water and water-glycol mixtures for heating systems, cooling and cold water, industrial water. The seal 120613693 to Wilo Bn, Dpn, IPn pumps is made in AQ1EGG materials. It is also possible to perform in other... Read more →
12 Jan 2021
Pump for raising the pressure and pumping water in technical, industrial and domestic areas of the CNS -2,2-1,87. The mechanical seal is used in graphite / silicon carbide (tungsten carbide ) / ethylene propylene rubber EPDM materials The R-706E mechanical seal is designed to operate at -20°~120°, pressure ≤1.7 Mpa, speed ≤15 m / s. Read more →
12 Jan 2021
Mechanical seals in the circulation pump of the Nocchi A2LD 65-160 D heating system (Pentair Water) are made in materials: carborundum/carborundum, the ring gasket is ethylene propylene rubber. Our specialists replaced the mechanical seals with R-MG12 Read more →
29 Dec 2020
The AL -1154/4 pump requires a shaft seal. Medium-ethylene glycol solution. Installed on the ice arena. The supplied ones work for 1-2 years. What this may be related to. The estimated ambient temperature is -10/-15, but it can be lower. The phenomenon of working with discharge is possible, with a lack of glycol (Antifreeze A40). At the same facility, pumps installed in a... Read more →
26 posts